Can I clean my bike with WD40?

Can I use WD-40 to clean my bike?

Can I use WD-40 on my bike chain? Yes, WD-40 can be used and will not damage your bike chain. It is primarily a cleaner, but also a light lubricant that will last best in dry conditions. It’s not the best lubricant for riding in wet conditions, because it will come off quickly.

What should you not use WD40 on?

But Don’t Spray It On:

  • Door hinges. Sure, WD-40 will stop the squeaking, but it also attracts dust and dirt. …
  • Bike chains. WD-40 can cause dirt and dust to stick to a chain. …
  • Paintball guns. WD-40 can melt the seals in the guns.
  • Locks. …
  • iPods and iPads.

Why is WD40 bad for bike chains?

WD40 is primarily a solvent, which means that it dissolves contaminates so parts get nice and clean. As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all.

What is WD40 used for?

WD-40® Multi-Use Product protects metal from rust and corrosion, penetrates stuck parts, displaces moisture and lubricates almost anything. It even removes grease, grime and more from most surfaces.

THIS IS IMPORTANT:  You asked: How do I choose a mountain bike bar?

Can I use wd40 on derailleur?

WD-40 is also useful to clean the derailleurs to remove any dirt and tough grime on your bike. Put the WD-40 on the derailleurs and let it soak in for a few minutes. And then clean.

What can I use instead of bike degreaser?

While you can use automotive or bicycle specific degreaser, kerosene is a good low cost (but smelly) alternative. It is commonly available at supermarkets and hardware stores and does a great job of dissolving chain grime.

How do I dry my bike after washing it?

Allow the bike to dry after rinsing. Use compressed air if available, but do not blast bearings directly. Use a light lubricant such as CL-1 on the chain, pulley wheels, cables, and pivots points.