Can I raise the handlebars on my Trek bike?

How do you raise the handlebars on a Trek hybrid bike?

Adjusting Handlebar Height

Use a 5 mm Allen wrench to loosen the top cap at the top of the stem. The top cap shouldn’t be very tight. Once you remove the bolt and cap, you’ll see the star nut inside the steering tube. Rearrange the stem and the spacers until the desired height is reached.

Can you raise the handlebars on a Trek mountain bike?

Another way to “raise” mountain-bike handlebars is to replace your flat bars with a riser model. These can be an inch or two higher than flat bars. It’s usually not a good idea to raise the handlebars too much.

How do you raise the handlebars on a Trek 3700?

The only way to raise the bars on a bike with a threadless steerer, like your’s has, is to get a new stem with a steeper rise or higher rise handle bars.

How do I raise the height of my handlebars?

How to set your handlebar height in five steps

  1. Step one – Get an idea of what you want. …
  2. Step two – Measure your comfort zone. …
  3. Step three – Loosen your stem cap and screws. …
  4. Step four – Remove your stem and adjust any spacers accordingly. …
  5. Step five – Re-tighten the stem cap and screws.
THIS IS IMPORTANT:  Is cycling 20 miles a day too much?

How high should mountain bike handlebars be?

The old rule of thumb that your handlebars should be level with your seat (at full climbing height) to 3 inches below your seat (at full climbing height) is a great place to start. In general, the taller you are the more drop from seat-height to bar-height you will have.

How do you remove Trek handlebars?

How to Remove Bicycle Handlebars

  1. Disconnect any cables attached to the handlebars. …
  2. Turn the locknut counterclockwise until the handlebars move. …
  3. Pull the handlebars up until they completely detach from the bike’s frame.
  4. Disconnect the cables or handlebar attachments using a screwdriver or Allen wrench.

Should I use a stem riser?

Stem risers usually are safer when they are fitted on non-carbon steerer tubes. That’s because carbon steerer tubes are weaker and likely to bend. … Adjustable stems are also safer and can be fitted on most bikes. You, however, should avoid fitting them on mountain bikes as they are not built for such abuse.