Quick Answer: Should you oil bike cables?

Can you use WD40 as cable lube?

WD 40 is a great quick and dirty solution to sticky cables. It flows great and flushes out that damn cable lube that gums up and attracts dirt. Use it regularly to keep moisture and dirt out.

Is it OK to use WD40 on bike chain?

You can use WD-40 Multi-Use-Product. It is a water based lubricant that provides the right amount of lubrication to the chain lube. … WD-40 is a great bike chain lube water based lubricant and will not only lubricate the chain well, but will also keep it rust and corrosion free.

Can I use chain lube on cables?

The mechanism will force the lube into the cable housing and down the inner parts of the cable. You can use general cable lube or cable lube specifically advertised for dirt bikes. … Avoid general or multipurpose lubricants or any unrelated oils, like motor oil. Do not use chain lube for your cables.

How do you get rust off bike cables?

Try removing the rust with some 000 or 0000 steel wool and see how bad the rust really is. Experiment with dry steel wool/steel wool and a little WD-40 or other light lubricant and see what works best for you. Even cables can be cleaned and re-lubricated if they are not compromised.

THIS IS IMPORTANT:  Your question: Can cyclists drink and ride?

What is wire pulling lubricant?

What is a cable pulling lubricant? A cable pulling lubricant is a specialty product designed to reduce the friction of a cable while pulling into a conduit. The friction reduction lowers the force required to pull the cable into the conduit. This reduces the tension (tensile stress) on the cable during installation.

What can I use in place of cable lube?

Braided hollow rope can be nice as you can expand the end and use it like a Chinese finger cuff to grab the ends of the wires (use tape as well.) If the conduit is exterior and the wires are correctly rated for exterior conduit, you could use water as a lubricant.