You asked: How can I make my motorcycle suspension softer?

How do you soften motorcycle suspension?

Spin the retaining collar on the shock in the appropriate direction to achieve the amount of desired preload. Spinning the collar down increases preload and reduces the amount of sag. Spinning the collar upwards reduces preload and increases sag. Do so until you reach the desired amount of sag.

How do you fix a stiff motorcycle suspension?

Try this: Go to the bumpiest section where your bike is least happy. With suspension fluid now warm from getting there, turn the compression damping adjuster on the rear shock all the way soft, turn the rebound-damping adjuster mostly all the way soft, and ride back and forth at your usual pace.

How do you soften a motorcycle rear suspension?

To adjust the preload on your bike’s rear shock, you will need a C-spanner to loosen the top locking ring and spin it up the shock to gain access to the adjuster ring. If you want to increase preload so the spring has less travel and to make the bike feel stiffer, turn the adjuster ring clockwise.

How do you soften suspension?

How to Soften Car Suspension

  1. Install softer shocks and struts. As the primary component that affects your vehicle’s ride quality, shocks and struts have a very big impact. …
  2. Adjust the shocks to a softer setting, if you have adjustable shocks. …
  3. Install softer springs. …
  4. Replace the bushings in the suspension.
THIS IS IMPORTANT:  Is it bad to shift a motorcycle without the clutch?

Which is better soft or stiff suspension?

A stiff suspension will make sure it’s pushed exactly where it needs to go. Your softer road suspension will keep your back happy so you’re not bouncing over every imperfection in the road. The proper setup for you might fall somewhere in between, and if you watch this video you’ll know why.

Why is my front suspension stiff?

Lowering the suspension means reducing the total vertical distance the wheel can travel and increases the ride stiffness at the same time. In addition, if the dampers were also replaced with sportier (stiffer) ones, the overall quality of the car’s ride will undoubtedly suffer.

How do you soften front forks?

Though in some cases this is found on the bottom of the fork and the rebound is on the top – check your bike manual. If you wind the screw in towards the ‘H’ (clockwise) the downward action of the fork will harden. Alternatively, if you wind the clicker out (anti clockwise) the fork will soften.

How do I make my rear shocks softer?

The compression adjuster is located on the shock reservoir. When you turn the screw clockwise, you make the damping harder (or slower or heavier). Turn the screw counter-clockwise and the damping will get softer (or faster or lighter). Before you ride your bike, set the compression clicker on a base number.

How do you adjust preload on a suspension?

Suspension Setup Guide

  1. Keep detailed notes on all your settings so that you can refer back to them. …
  2. The front preload adjuster is the large nut on top of the fork tube. …
  3. Rear preload is adjusted by turning the collar on top of the spring, either in notched increments or turns of a threaded adjuster.
THIS IS IMPORTANT:  How does a motorcycle divide a lane to determine positioning?